Forum

Hi Mike. This is Mike from Burlington, Ontario. Our check pilot is over 6 feet. It depends on how long your torso is I guess. BTW I am putting mine on the market. It was completed in 2022. Now has 30 ish hours. Lycoming IO-360 B1E, 180 hp. 10 hours. New Hertzell constant speed. Dual GRT Horizon scre...

Hi Jason,
Welcome to the wonderful world of Falcos.
My buddy and I spent 18 years completing C-GVKY in Burlington, Ontario. Hope to have it at Oshkosh in July.
You should consider joining us at the Falco dinner on Tuesday, July 25 in Oshkosh.
Best
Mike

Hi Folks it's that time again.
Please join the Falco gang at FOX RIVER BREWERY ON THE WATER
1501 ARBORETUM DRIVE
OSHKOSH WISCONSIN 54901
920.232.2337
Tuesday July 25 at 17:30 hours.
Let me know how many in your party.
Thanks

Hi folks,
I am having trouble in getting the doors to close completely when either in the extend mode or retract mode. The linkage/actuator as per the drawing is being used and careful attention was paid to the measurements outlined therein. Any suggestions would be appreciated.

Date: Tuesday, July 26
Time: 6:00pm
Where: Fox River Brewing Company, Oshkosh.

Please let me know who is coming and how many are in your party.

Hi Falco Flyers, The Falco dinner has been arranged for Tuesday, July 27, 2021, at the Fox River Brewing Company. FOX RIVER BREWING CO. www.foxriverbrewing.com 1501 Arboretum Dr, Oshkosh, WI 54901 Reservation at this time is for 20 people. Let me know who is coming so I can advise the restaurant acc...

I am Michael Schuler located in Burlington, Ontario, Canada. Burlington is a part of the Greater Toronto Area (GTA) with a population of around 6 million. Its industrial base comprises an inventory of some 900 million square feet. Compared to Chicago with about a billion square feet. I, together wit...

I used T88 as an adhesive and West 105 resin for laminating, coating the interior, and fiberglassing the exterior. Many builders consider epoxy as the way to go but there is a caution about leaving the airplane in direct sunlight to a point where the surface heats up to extreme levels. The wise will...

I am having difficulty in understanding how the front portion of the doors fit. The drawing shows that the hinges are at the fuselage/door bay edge. The nose gear linkage is below that level. And, the triangular piece of nose gear door (affixed to the strut) fairs into the lower cowl such that it is...

Nice to hear that this forum exists.

Our Falco is nearing completion!