Gear Up Problems

Anything you want to talk about.
Post Reply
bjoar-b
Posts: 1
Joined: Fri Oct 16, 2020 5:23 am

Gear Up Problems

Post by bjoar-b »

Hi!

I got snag on the gear up circuit, no response when selecting gear up. I have checked the gear up relay, and it’s working fine so no trouble on that.

So, the snag has to be from the gear handle to the relay. No response in flight, and no response on jacks even when I put a jumper to go around pitot pressure switch.

Have anyone some ideas regarding this problem?

Regards.
Bjørn Brekke
Falco 1487 LN-LOB
User avatar
flysavvy_
Posts: 2
Joined: Tue Oct 13, 2020 4:52 pm

Gear Up Problems

Post by flysavvy_ »

Bjørn, just to confirm, there are two terminals at the pitot pressure relay, can you confirm you jumped to the correct one?

One would jump the relay, while the other would go to the indicator or switch in the cockpit.

There's always the chance of a broken wire, but otherwise I would expect the issue to be your up-limit switch or selector switch.
Savannah
ASEL CFII; A&P, IA
Falco N811LW
User avatar
Alfred Scott
Posts: 7
Joined: Tue Oct 13, 2020 11:41 am
Location: Richmond, VA
Contact:

Gear Up Problems

Post by Alfred Scott »

Electrical problems are always mechanical problems. I suspect a loose connection.

The only way to diagnose a problem with the retraction system is to use the gear logic drawings and trace things down.

Let me also mention that the forum has now been hit by spam, so we have changed it so your first two posts will have to be approved by a moderator, then it will be an open road for you thereafter.

Alfred
Alfred P. Scott
5407 Patterson Ave, Suite 202B
Richmond
VA 23226

(804) 353-1713
cell: (804) 690-4591
alfred@seqair.com
alfred.scott@me.com
www.seqair.com
NE Falco
Posts: 2
Joined: Sat Oct 17, 2020 6:49 pm

Gear Up Problems

Post by NE Falco »

Bjorn,

I had a very similar issue with my gear a few months back. It turned out to be the gear system transistor (Q3). Replaced the transistor, trouble free ever since. Ref: Falco Electrical System, Pg. 9-7, Fig. 9-7. Also see Falco Construction Drawings, Sheet A39 and Sheet A43, Detail A.

It only affected gear retraction, the gear came down normally.

I hope this helps.

George
Post Reply