Craig Bransfield

Ready for float sanding for the bottom skins.

Float sanding using Tee-bar with carbide 'flat' glued to the face.

Craig also used a disc sander on a pneumatic right-angle drill for the big stuff.

Lower forward skins pre-scarfed and ready to glue.

Craig says "I was doing these six at a time. Each set of skins took about one day from 'Go' to 'Whoa'".

Damp towels over the skins to keep them in a slightly
'expanded' state until the glue kicked (one or two days).

Lower forward skins finished.

Go back to Wing